Save one to your computer to print it alone, or Print Six Paper Egg Stands on One Page. Direct links to the Printer Friendly page won't work, so you must link to this page to share it.
The egg stands should support your Easter eggs whether you print them on plain computer paper or card stock.
Cut out each design, then cut a slit about a quarter inch in from one end, from the top to the center.
Cut a corresponding slit, a quarter inch from the other end, from the bottom to the center. You can see a sample egg stand cut this way in our photo.
Bring both ends together at the back, sliding the top slit over the bottom one, so that the tabs end up on the inside. Your paper egg stand is now complete.